| Citation: |
CHEN Dingchao，WANG Xiangyu，BAI Jianbiao，et al. Full cycle evolution law of energy-stress in the surrounding rock of the gob-side entry driving for adjacent advancing working face[J]. Coal Science and Technology，2025，53（4）：162−175. DOI: 10.12438/cst.2023-1923
|
The full cycle dynamic pressure impact of the lateral basic roof fracture, rotation, and sinking of the upward working face along the gob excavation roadway in the face of mining is significant, and the roadway deformation is difficult to maintain. This article takes the 15105 panel of Wenzhuang Coal Mine as the engineering background, and proposes to change the excavation trajectory of the roadway behind the unstable gob of 15103 panel, on the basis of the original 25 m coal pillar facing the gob, and reduce the width of the section coal pillar to 6 m for gob excavation. In order to demonstrate the feasibility of the plan, a numerical model was established using FLAC3D to simulate the evolution law of the energy stress full cycle of the surrounding rock of the roadway (driven heading for mining of 15103 panel, excavation of the unstable gob side roadway, and mining of the 15105 panel) under two scenarios: the original plan and the optimized plan. The simulation results show that: ① During driven heading for mining of 15103 panel, stress and energy are mainly concentrated on the gob side of the section coal pillar. ② During the excavation of the unstable gob side roadway, compared with the original plan, the optimized plan transferred the internal energy and stress of the 6 m coal pillar to the coal body side of the working face ③ During the mining period of the 15105 panel, when adopting the original plan, both energy and stress were concentrated towards the mining side of the 25 m coal pillar, with a peak stress of 31.2 MPa and a maximum energy of 192.4 kJ/m3. When adopting the optimization plan, both energy and stress are transferred to the solid coal side of the working face. The 6 m coal pillar has a certain bearing capacity, and the stress concentration is low and there is no obvious energy accumulation throughout the process. During the mining period, the peak stress inside the 6 m coal pillar is only 8.1 MPa, and the maximum energy is 126.7 kJ/m3. On this basis, the reliability of the optimization plan was determined, and combined with numerical simulation results and on-site geological conditions, it is proposed to divide the roadway into four sections: the face to face mining section, the gob excavation section, the gradient coal pillar section, and the gob excavation section. A zoning control system for the surrounding rock of the roadway was established, and anchor bolt support parameters were designed. Finally, industrial experiments were successfully conducted, and on-site monitoring results showed that the overall control effect of each section of the roadway was good.
| [1] |
程利兴,康红普,姜鹏飞,等. 深井沿空掘巷围岩变形破坏特征及控制技术研究[J]. 采矿与安全工程学报,2021,38(2):227−236.
CHENG Lixing,KANG Hongpu,JIANG Pengfei,et al. Deformation and failure characteristics and control technology of surrounding rocks in deeply gob-side entry driving[J]. Journal of Mining & Safety Engineering,2021,38(2):227−236.
|
| [2] |
李学华,鞠明和,贾尚昆,等. 沿空掘巷窄煤柱稳定性影响因素及工程应用研究[J]. 采矿与安全工程学报,2016,33(5):761−769.
LI Xuehua,JU Minghe,JIA Shangkun,et al. Study of influential factors on the stability of narrow coal pillar in gob-side entry driving and its engineering application[J]. Journal of Mining & Safety Engineering,2016,33(5):761−769.
|
| [3] |
张广超,何富连. 大断面综放沿空巷道煤柱合理宽度与围岩控制[J]. 岩土力学,2016,37(6):1721−1728,1736.
ZHANG Guangchao,HE Fulian. Pillar width determination and surrounding rocks control of gob-side entry with large cross-section and fully-mechanized mining[J]. Rock and Soil Mechanics,2016,37(6):1721−1728,1736.
|
| [4] |
耿行. 隔采空区迎采动沿空掘巷围岩控制技术研究[D]. 徐州:中国矿业大学,2019.
GENG Xing. Study on the stability control technology of surrounding rock for gob-side entry driving forward the mining face separate by a narrow goaf [D]. Xuzhou:China University of Mining and Technology,2019.
|
| [5] |
陈晓祥,王逸良,张天. 迎采动面沿空掘巷围岩变形规律及控制技术[J]. 煤矿安全,2020,51(6):66−71,76.
CHEN Xiaoxiang,WANG Yiliang,ZHANG Tian. Deformation law and control technique of surrounding rock in gob-side entry driving under driven heading for adjacent advancing coal face conditions[J]. Safety in Coal Mines,2020,51(6):66−71,76.
|
| [6] |
秦忠诚,杜金顿,刘佳,等. 采掘相向沿空掘巷动态分段围岩控制技术[J]. 煤矿安全,2016,47(11):155−158.
QIN Zhongcheng,DU Jindun,LIU Jia,et al. Dynamic sectional control technology for surrounding rock in gob-side entry driving with opposite mining direction[J]. Safety in Coal Mines,2016,47(11):155−158.
|
| [7] |
刘金海,曹允钦,魏振全,等. 深井厚煤层采空区迎采动隔离煤柱合理宽度研究[J]. 岩石力学与工程学报,2015,34(S2):4269−4277.
LIU Jinhai,CAO Yunqin,WEI Zhengquan,et al. Research on reasonable width of partition pillar close to goaf heading mining in thick seam of deep shaft[J]. Chinese Journal of Rock Mechanics and Engineering,2015,34(S2):4269−4277.
|
| [8] |
于洋,王襄禹,薛广哲,等. 迎采动工作面沿空掘巷动态分段围岩控制技术[J]. 煤炭科学技术,2013,41(7):43−46,50.
YU Yang,WANG Xiangyu,XUE Guangzhe,et al. Dynamic sectional control technology of surrounding rock in gateway driving along goaf forward to mining face[J]. Coal Science and Technology,2013,41(7):43−46,50.
|
| [9] |
李文峰,孙迎辉,杨波,等. 迎回采面沿空掘巷围岩控制技术实践[J]. 煤炭工程,2010,42(2):24−26. doi: 10.3969/j.issn.1671-0959.2010.02.012
LI Wenfeng,SUN Yinghui,YANG Bo,et al. Practices on surrounding rock control technology of gateway driving along goaf towards to coal mining face[J]. Coal Engineering,2010,42(2):24−26. doi: 10.3969/j.issn.1671-0959.2010.02.012
|
| [10] |
王傲,姚强岭,李学华,等. 采动高应力区沿空掘巷锚杆破断机理[J]. 中国矿业大学学报,2017,46(4):769−775.
WANG Ao,YAO Qiangling,LI Xuehua,et al. Bolt fracture mechanism of roadway driven along gob in high street area caused by mining[J]. Journal of China University of Mining & Technology,2017,46(4):769−775.
|
| [11] |
BAI J B,SHEN W L,GUO G L,et al. Roof deformation,failure characteristics,and preventive techniques of gob-side entry driving heading adjacent to the advancing working face[J]. Rock Mechanics and Rock Engineering,2015,48(6):2447−2458. doi: 10.1007/s00603-015-0713-2
|
| [12] |
张农,李学华,高明仕. 迎采动工作面沿空掘巷预拉力支护及工程应用[J]. 岩石力学与工程学报,2004,23(12):2100−2105. doi: 10.3321/j.issn:1000-6915.2004.12.029
ZHANG Nong,LI Xuehua,GAO Mingshi. Pretensioned support of roadway driven along next gob and heading adajacent advancing coal face and its application[J]. Chinese Journal of Rock Mechanics and Engineering,2004,23(12):2100−2105. doi: 10.3321/j.issn:1000-6915.2004.12.029
|
| [13] |
郭重托. 特厚煤层迎采扰动沿空掘巷围岩控制技术研究[J]. 煤炭工程,2020,52(11):42−46.
GUO (Chong| Zhong)(Tuo). Surrounding rock control for gob-side entry driving toward mining disturbance in extra-thick coal seam[J]. Coal Engineering,2020,52(11):42−46.
|
| [14] |
张雷. 冲击危险区迎采沿空巷道切顶护巷防冲技术[J]. 煤矿安全,2021,52(2):98−104.
ZHANG Lei. Preventing rock burst technology by roof cutting and roadway protection in mining along goaf roadway of dangerous area[J]. Safety in Coal Mines,2021,52(2):98−104.
|
| [15] |
王猛,柏建彪,王襄禹,等. 迎采动面沿空掘巷围岩变形规律及控制技术[J]. 采矿与安全工程学报,2012,29(2):197−202.
WANG Meng,BAI Jianbiao,WANG Xiangyu,et al. The surrounding rock deformation rule and control technique of the roadway driven along goaf and heading for adjacent advancing coal face[J]. Journal of Mining & Safety Engineering,2012,29(2):197−202.
|
| [16] |
YAVUZ H. An estimation method for cover pressure re-establishment distance and pressure distribution in the goaf of longwall coal mines[J]. International Journal of Rock Mechanics and Mining Sciences,2004,41(2):193−205. doi: 10.1016/S1365-1609(03)00082-0
|
| [17] |
蒋力帅,武泉森,李小裕,等. 采动应力与采空区压实承载耦合分析方法研究[J]. 煤炭学报,2017,42(8):1951−1959.
JIANG Lishuai,WU Quansen,LI Xiaoyu,et al. Numerical simulation on coupling method between mining-induced stress and goaf compression[J]. Journal of China Coal Society,2017,42(8):1951−1959.
|
| [18] |
张广超,陶广哲,曹志国,等. 考虑垮落岩体应变硬化特性的采场覆岩破坏特征研究[J]. 煤炭科学技术,2022,50(3):46−52.
ZHANG Guangchao,TAO Guangzhe,CAO Zhiguo,et al. Study on failure characteristics of stope overlying rock considering strain hardening characteristics of caved rock mass[J]. Coal Science and Technology,2022,50(3):46−52.
|
| [19] |
陈定超,王襄禹,吴帅,等. 柔模混凝土墙沿空留巷围岩稳定机理及控制技术研究(英文)[J]. Journal of Central South University,2023,30(9):2966−2982. doi: 10.1007/s11771-023-5436-z
CHEN Dingchao,WANG Xiangyu,WU Shuai,et al. Study on stability mechanism and control techniques of surrounding rock in gob-side entry retaining with flexible formwork concrete wall[J]. Journal of Central South University,2023,30(9):2966−2982. doi: 10.1007/s11771-023-5436-z
|
| [20] |
JAISWAL A,SHRIVASTVA B K. Numerical simulation of coal pillar strength[J]. International Journal of Rock Mechanics and Mining Sciences,2009,46(4):779−788. doi: 10.1016/j.ijrmms.2008.11.003
|
| [21] |
XIA Z,YAO Q L,MENG G S,et al. Numerical study of stability of mining roadways with 6.0-m section coal pillars under influence of repeated mining[J]. International Journal of Rock Mechanics and Mining Sciences,2021,138:104641. doi: 10.1016/j.ijrmms.2021.104641
|
| [22] |
LI W F,BAI J B,PENG S,et al. Numerical modeling for yield pillar design:A case study[J]. Rock Mechanics and Rock Engineering,2015,48(1):305−318. doi: 10.1007/s00603-013-0539-8
|
| [23] |
孙飞跃,范俊奇,郭佳奇,等. 基于能量原理的岩爆倾向性判据[J]. 高压物理学报,2021,35(3):158−172.
SUN Feiyue,FAN Junqi,GUO Jiaqi,et al. Rockburst proneness criterion based on energy principle[J]. Chinese journal of high pressure physics,2021,35(3):158−172.
|
| [24] |
镐振,郭林峰,赵希栋,等. 回采巷道围岩冲击破坏能量特征分析[J]. 煤炭学报,2020,45(12):3995−4005.
HAO Zhen,GUO Linfeng,ZHAO Xidong,et al. Analysis of burst failure energy characteristics of mining roadway surrounding rock[J]. Journal of China Coal Society,2020,45(12):3995−4005.
|
Supported by: Beijing Renhe Information Technology Co., Ltd. 
DownLoad: